Creating Bar Bending schedule, Different Door types, and Creation of standard drawing templates using AutoCad

1. Create the templates as shown in Figures. Take the size of the title block as per industry standards or you can assume it as per the size of the paper. Use text and attributes wherever required. After creating the title block you need to save it as a block with names: Custom1_titleblock and Custom2_titleblock, respectively.

• First set the units as (mm)
• Then draw the title block as by using line command.
• Using Teaxt command and write the text and place it as well.
• Then make it all as a single block by using Block command.

2. Create the doors type for warehouse as shown in the Figure. You need to create each door type as per standard size or given dimensions. Create the blocks of this door type after creating them.

• First set the units as (mm)
• Then draw the doors by using line command.
• The figure must be drawn by the given measurements.
• Finally give the Dimension command to shown the measurements and make it as a Block by using Block command.