Creating Architectural and Structural model with 3D rendering using REVIT
Q.1
Ans: I was selected a office building.
Q.2
Ans: assume reasonable assumption for geographic and location details for project model as follow
my project is in plain area.
it is in commercial area.
MODELLING REQUIREMENTS FROM NCB ARE:
an exit must be provided in every building so as to permit safe escape of employes
in case of earthquake or fire hazards.
the minimum height of basement should be 2.5m and maximum height should be 4.5m.
Q.3
Aim: using structural model include following components
Step by step procedure as follow:
open revit and make horizontal and vertical grids
go to the elevation and increase the number of levels upto roof and change their names
select column from ribbon and place the columns at intersection of grids .
change the view to 3d ,you get an interface
place another column on the grid intersection from ground floor to first floor.
now select beam from the ribbon and connect this beam to different columns
now go to isolated option from the ribbon and place them on the different columns
select the entire figure and go to the copy option and assign them to first floor and second floor.
now go to the roof option and change the view to ground floor and select points and make a loop and assign them
to first and second floor and change the view to 3d.
now go to the wall option and select the floor you want to assign the wall ,copy it and assign to different levels.
change the front wall to curtain wall
from the properties option change the colour and material of roof and walls.
lets make a roof to place stairs, go to the floor option and draw a rectangle in the plan ,change the view to 3d
and copy it to different levels
draw a shaft and make stairs
and make doors at the entrance of stairs.
Q.4
Aim: Using the architectural model include the following components based on type of structure selected
with the same grids drawn in the previous plan draw a wall along the boundary.
draw the interior partitions and place the required furniture and components in the plan and change the
view to 3d.
change the front walls of the building with curtain walls or glazed panel as shown in figure and
copy the entire figure and place it to the first floor
draw the roof by making a rectangle along all the sides of second floor.
go to place a component and add the required components from the library and place it in the figure.
Q.5
Q.6
Aim: by using rendering setting render images of the 3D model
in order to render any figure go to the render option from the ribbon and change the settings you want
and click render figure will turn to realistic