Creating a Residence Layout, Seating plan, Toilet and Utility room plan using AutoCad
1. Residence Plan:
Sketch the layout of a residence as shown in the Figure 1. Consider all dimensions as reference to sketch the unit plan. Also the text in the layout are only for reference. Assume the missing dimensions. Also, refer the schedule for size of the doors.
AIM :
To Draw the floor plan using AutoCAD software
INTRODUCTION
This type of drawing can be drawn by using the line command or rectangle command with specifying the length and angle of the drawing
PROCEDURE
• Open AutoCAD software
• Choose the imperial template and start from scratch
• Set the units to engineering and select ok
• Choose line command by pressing 'L' enter and to give the dimensions to the command, the line was drawn.
• Indicate the direction of the line by the keeping ortho mode is ON . Give the line measurement as per given in drawing as question
• After completion of drawing exit from line command and starting giving dimensions
• To give dimensions enter DIM Dimension and select the line to locate the dimension in object
• To set the properties of dimension enter DIMS' (Dimension style) and specity the sizes as per requirements
• To save the file go to the AutoCAD application and choose the same as option
• Now select the snipping tool to take screenshot
RESULT :
2. Sketch the seating plan for an outdoor canopy. Assume the dimensions for the seating. Also, consider the dimensions in mm.
AIM :
To Draw the round table drawing using AutoCAD software
INTRODUCTION
This type of drawing can be drawn by using the line command or circle command with specifying the length and angle of the drawing
PROCEDURE
• Open AutoCAD software
• Choose the imperial template and start from scratch
• Set the units to decimal and select ok
• Choose line command by pressing 'L' enter and to give the dimensions to the command, the line was drawn.
• Indicate the direction of the line by the keeping ortho mode is ON . Give the line measurement as per given in drawing as question
• After completion of drawing exit from line command and starting giving dimensions
• To give dimensions enter DIM Dimension and select the line to locate the dimension in object
• To set the properties of dimension enter DIMS' (Dimension style) and specity the sizes as per requirements
• To save the file go to the AutoCAD application and choose the same as option
• Now select the snipping tool to take screenshot
RESULT :
3. Sketch the part plan for the toilers and utilities room. Consider the outer wall thickness as 300mm and inner wall thickness as 150mm. Also, assume the missing dimension, Texts, dimensions, and hatches are only for references. Also, symbols for toilets and w/c are also for references.
AIM :
To Draw the floor plan using AutoCAD software
INTRODUCTION
This type of drawing can be drawn by using the line command or circle command with specifying the length and angle of the drawing
PROCEDURE
• Open AutoCAD software
• Choose the imperial template and start from scratch
• Set the units to decimal and select ok
• Choose line command by pressing 'L' enter and to give the dimensions to the command, the line was drawn.
• Indicate the direction of the line by the keeping ortho mode is ON . Give the line measurement as per given in drawing as question
• After completion of drawing exit from line command and starting giving dimensions
• To give dimensions enter DIM Dimension and select the line to locate the dimension in object
• To set the properties of dimension enter DIMS' (Dimension style) and specity the sizes as per requirements
• To save the file go to the AutoCAD application and choose the same as option
• Now select the snipping tool to take screenshot
RESULT :
