Challenge

Creating a Floor plan, Footing detail and Isometric view using AutoCad

aim & introduction

To complete the given floor plan,footing detail and the isometric view using autocad.

in detail for an attachment

c1 is cross section of load bearing wall over spread footing step by step

set units in autocad
using rectangle command give size like 0.9*0.25,0.5*0.4,0.4*0.4,0.3*0.6,and 0.3*1

and these rectangles are one by one.

then using trim commond delete unnessary line as per drawing
using line command 1.15 units in left direction then 0.15 units 0.3 units as per drawing to completed

cross section of isolated footing

using line command draw 1 unit line 0.15 unit y axis and then draw inclined line then continue the line 1.6units.
then apply mirror command
offset 0.04 units in each side main bar
from the top offset the line 0.2 units upto bottom of footing this strrups
bottom line offset 0.04 units fillet comman use to complete main bar

line diagrame of building

draw a rec 3.6*3.6 units bed room
then face of living room the open is create as measurments
stair is draw 1 unit towards living room and the line is offset 0.3 units as drawing
then the living room create 4.2 unts x axis and 3.6 unit is y axis these are repeate to complete the drawing

cross section of load bearing wall showing foundation details

draw rec for 0.9*0.45,0.6*0.4,0.5*0.3,0.4*0.6 and 0.3 *1 units
then the place the rec one by one then trim unnessary lines to complete the drawing

isometric view of steps

in top view create steps 0.3*0.15 unts to repeate and draw few more steps by using polyline
then draw a line bottom of step and it offset 0.15 unit
then 3d roate command based on x axis
then extrude 1 unis to complete the steps

results

Given diagrame are completed except one and all completed drawings are uploaded below.

Ship work like this
in your own course.