Creating a Floor plan, Footing detail and Isometric view using AutoCad

Aim:- Creating a floor plan, footing details and isometric view using autocad.

Introduction:-

In this project by using basic command make a footing details and flooring plan in 2D.Isometric drawings are not actual 3D drawings, they are made with 2D geometries but they appear like 3D. Isometric drawing in AutoCAD can be made by tilting viewing angle to 30 degrees for all of its sides in the 2D plane.

Procedure:-

1) to make a footing details:-

a) Deside the the drawing unit as per project requirement.

b) By using line command make a footing with required sizes.

c) In over spread footing make base with rectangle command, and by using line draw a sprea footing. by using line command draw horizontal line and the by using offset command make another line with distance. In between groun level and upper portion footing make a staircase by using line command and with distance and angle make a staircase.

d) In 3rd type of footing make a base with line and side slopes are given with dimension and an angle method. then draw a vertical line with dimension close the oter side of the footing hen by using offset command draw a stright steel bar by usin copy and array draw stirrups as per the drawing.

e) Draw bed room rectangle from the base point with dimension 3.6X3.6 by using breal comman cut the line in between rectangle with opening. again draw stair block cut line by using trim command then by using offset command raw steps of strair. then draw rectangle again break line of opeing.

d) Make a setting to change isometric drafting. By using three option plane right, left, top make a isometric view of steps and gable wall.

Result:-

With a different command and basic geometric figures we make a different view of footing, flooring plan and isometric view of gable wall and steps. With a report attached a drawing of challenge.