Creating a Floor plan, Footing detail and Isometric view using AutoCad

Aim:

Creating a Floor plan, Footing detail and Isometric view using AutoCad for the given drawing.

Introduction:

The given drawing are drawn using the line, Fillet, circle, arc and Isometric plan for isometric drawing where F5 key is used to change the plane in the autocad.

Procedure:

• First units are set in the drawing sheet using decimal as the drawing are given in decimal.
• Then the drawing are started using line command for the given drawing.
• C1 drawing the line is started and a length of 0.9 in horizontal direction and then 0.25 in vertical direction the 0.9 in left side horizontal direction and closed. Then 0.2 from top left corner and then 0.5 as line then 0.4 vertical direction and so on as given in the drawing.
• C2 in this drawing line, offset command are used in it with given measurements to complete the drawing.
• C3 in this drawing line are drawn in horizontal and vertical direction as given in the drawing and steps are drawn using offset command.
• C4 in this drawing line, offset command and trim command are used in it with given measurements to complete the drawing.
• C5 this drawing is drawn using setting the sheet in isometric plan and then F5 key is used to change the direction of line and then then line are drawn as per given picture.
• C6 this drawing is drawn using setting the sheet in isometric plan and then F5 key is used to change the direction of line and then then line are drawn as per given picture.

Result :

The given drawing are drawn as per the command thought to us in week 2 session and it is drawn correctly.