Creating a Floor plan, Footing detail and Isometric view using AutoCad

Aim: To create a floor plan, footing detail and isometric view using Autocad

Introduction: By using various autocad tools, we can create floor plan as well as elevation and footing details

The isometric view is nothing but 3D view where we can find three axis in which the drawing has been created along three axis direction i.e, x, y and z axis 

Procedure for creating a floor plan:

First we have to uderstand a architectural elements that we are going to draft like door, windows, etc..

The thickness of exterior walls are taken as 9inches and the thickness of interior wall are taken as 4.5inches 

Set a unit either in feetinches or in mm 

Set a limit 

Give Zoom all command

Draw a wall using xline command taken from left to right and draw offset for wall thickness, use chamfer wherever it is necessary in corner edge 

Draft a door and windows wherever it is necessary from the schedule details given in the drawing details and draw a staircase if it is a G+1, G+2 and so on...

Insert a blocks like furnitures, washroom etc

C1 drawing

Aim: To create a C/S of load bearing wall over spread footing using autocad software

Introduction:

For this drawing we need to have a rectangle tool, line tool and dimension tool to measure the lenth of the object

Procedure:

Initially we have to set a unit to metric system in order to have a drwaing in mm 

We should limits to adjust the space

And we can draw a objects using various tools 

To go for isometric space go to settings near the snap mode right click and there we can find isometric snap click on that and 3D space will create