Challenge 8 : Concept Modeling of Seats

1. TITTLE OF THE PROJECT= Concept Modeling of Seats

2. OBJECTIVE = THIS PROJECT MAIN OBJECT IS THAT BASICALY STUDENTS CAN LEARN AUTOMOBILE INTERIOR PARTS DEIGNER AND INCREASE THEIR THINKING POWER, INCREASE THE BUILDING TECHNIQUES AND SURFACE LAYOUT, PATCHES CUT OUT AND STUDENTS ALSO LEARN WHERE WE CAN START THE MODEL MAKING.

3. INTRODUCTION = THE FIRST THING IS THAT THE STUDENT CAN FIND WHICH CURV START AND ENDS. IN TIS SESSION WE LEARNED WHICH PLACE PSE AND WHICH TYPE OF SURFACE. IN THIS MODEL WE USED MOSTLY FREE-FROM BLEND CURV BECAUSE IN A SEAT LOT OF CURVATURE POINTS THAT WHY.

4. IN THIS PROJECT WE USE LOTS OF COMMANDS LIKE:-

(i) WE IMPORT THE CANVAS IMAGE.

(ii) WE START THE MAKING CURVES AND WHEN WE MAKE THE CURV, WE USE CV AND BLEND CURV.

(iii) AND WE START THE MAKE THE PROJECT IN A SEPARATE WAY LIKE FRIST WE MAKE THE HEADREST AND THEN BACK SUPPORT AND BASE PART.

5. TOOLS:-

(i) CURU

(ii) BLEND CURV

(iii) EXTEND COMMAND

(iv) FREE FROM BLEND CURV

(v) SKIN

(vi) MRAIL AND BRAIL

(vii) SQUEAR

(viii) TRIM

(ix) PROJECT

(x) INTERSECT

(xi) SYMMTERY

6. NOW IAM IS GOING TO PRESENT THE MODEL PICTURES:-