Challenge 5 : Concept Modeling of Car Bumper

CONCEPT MODELLING OF CAR BUMPER

Objective:

     This project aims to create a smooth surface for the front and rear car bumper

Introduction:

     In this project, we are going to see the tools which were used in creating curves, surfaces, and continuities. The tools I have used and where it is used will be covered in detail in this project.

 Methodology:

In the starting process, I have used the blueprint provided to generate the model and as per the guidelines I have done the car's rear bumper using the rear view of the car blueprint. let's see the process in a flowchart.

Flowchart:

     Importing the blueprint and visualizing the model before designing

                                               ↓

    Started to model by creating curves and lines for a part of the bumper

                                               ↓

       By using appropriate tools model the part of the bumper

                                               ↓

 By using the symmetry option creating the symmetry part of the car bumper to fully complete the model

 Description:

• Square tool - used when there is a four-sided curve that is completely interlaced without any gap
• Rail tool - used when there are 1 rail and 2 generation curves and 2 rail curves and 1 generation curve
• Attach and detach tools- attach and detach tools are used for attaching and detaching any surface or curves, commonly used to separate the spans in the curves 
• skin tool - used to create surface across curve network
• Align tool - align tool aligns the surface end to meet the requirement with respect to continuity
• Expandtool - used to expand a curve or surface beyond its current endpoint
• Project tool - used to project a certain curve to a surface, which is later used to trim or split
• Multi-surface draft tool - used to extrude single or multiple curves with angle or normal straight surfaces
• Surface continuity tool - used to check the continuity between surfaces
• Intersect tool - similar to project tool, used to project the curves on the surface at the intersections between the existing surface 
• trim tool - Used to trim or split the surfaces using curves on surfaces, which is used after using the project or intersect tools

Conclusion:

    Here the project is completed and the corresponding tools were successfully learned and executed wherever necessary.