Challenge 5 : Concept Modeling of Car Bumper

Concept Modeling of Car Bumper:

Objective:

Creating surface of a car bumper

Introduction:

To create a surface over the car bumper wiremodel.

Design methodology:

Views:

Rail tool:

Creates a surface over the set of curves by generationcurve and primary curve.

Skin tool:

Creates a surface across the set of curves.

Square tool:

Creates a surface only when the four side of curves is present.

Align tool:

It connects the curves and also there are G0 , G1,G2 ,G3 modes are availabe to fillet the edges

Project tool:

It is used to project the curves to the selected surface.

Trim tool:

It is used to trim the selected surfaces.

Conclusion:

The surface of a car bumper is created