Project

Analysis on a plate with a hole

Aim :- To perform a static analysis on two models of plate with holes

Objective :-

To perform a static analysis on two models of plate with holes (plate with single hole and a plate with three holes )
To apply a fixed relation to one of the short side of the plate and apply a force of 1000N on the other such that the plate is stretched.
Run the analysis and compare the results for stress, strain and displacement

3D Model :-

Procedure :-

The procedure for the plate with one hole and three holes is shown below
For all the two cases the part material was selected as Alloy steel
The fixtures command is used to fix the one vertical face so as to perform the operation
Load of 1000N was applied on the opposite face to the fixed face in each case
Mesh value was selected as 6mm ( ie the manual mesh )
Finally the results for stress,strain & displacement were obtained for the each case

Case-1 Plate with one hole :-

Case-2 Plate with three holes :-

Result :-

Thus we have studied the static analysis on two models of plate with holes
Modelled the plate with single and three holes and ran the simulation
Performed the static analysis for the two cases and obtained the results for stress, strain and displacement

Case-1 Plate with one hole :-

The below video shows the analysis of plate with one hole for three conditions as stress,strain & displacement analysis
Also the result comparision is shown for the stress,strain & displacement

Case-2 Plate with three holes :-

The below video shows the analysis of plate with three hole for three conditions as stress,strain & displacement analysis
Also the result comparision is shown for the stress,strain & displacement

Conclusion :-

For the case 1 the values for the stress and strain seems to be higher than the case 2
The case 2 has less stress values compared to case 1 as the plate has three holes
Thus in case 2 ie plate with three holes the 2 extra holes on the sides of the main hole acts as an auxillary hole and thus provide reduction in stress concentration factor
The comparision of two case results also shows that the displacement is more in case 2 than case 1
Thus the best suited case is the analysis on a plate with three holes

Ship work like this
in your own course.