Advanced Sheet Metal Design Using NX Cad Challenge_6_Bracket

Title of the Project:

Bracket

OBJECTIVE:

To design a Bracket using sheet metal.

INTRODUCTION:

In this project we design the Bracket using sheet metal by using the tools such as contour flange, normal cut-out, Break corner, unbend, bead, holes and Rebend.

DESIGN METHEDOLOGY:

DESCRIPTION:

The features used to create dimple are

1.sketch: It is used to create the 2D sketches.

2.Contour Flange: It is used to make base with the sketch without tab.

3.Normal cut-out: this tool is used to cut the sheet metal with the directions.

5.Unbend: It is used to unbend the component.
6. Rebend: It is used to Rebend the component

7.Bead: It is used to make beads on surfaces.

8.Hole: It is used to make holes for the sheet metal.

MODEL IMAGES:

Front View:

Top View:

Side View:

Isometric View:

Conclusion:

Bracket design was done successfully in sheet metal by using Siemens NX.