Project 1 - PFI Engine simulation(Hydro case)

OBJECTIVE: My objective of this project is to mesh the solid parts using the required crietria of mesh by obtaining their mid surface.   PROCEDURE: In order to mesh the given solid parts according to our desired criteria of mesh, following steps have been taken: 1) Obtain the midsurface of the given solid part by…

OBJECTIVE: The main objective of this project is to mesh and connect the cross section of two parts with the required elements of required cross section.  PROCEDURE:  1. Firstly, the solid part is converted into midsurfaces using midsurface options and the midsurface thus obtained are meshed using the automesh…

                                                                        Design of Yatch   Objective:  The objective of this project is to design all the components of Yatch using Solidworks software and assemble all the parts accordingly.   Introduction: A yacht is a sail or power vessel used for pleasure, cruising, or…

                                                                      Design of a Chopper using Solidworks   Objective: The main objective…

                      Fig.1 Mass flow variation in outer and inner boundary                                     Fig.2 Density variation in outer and inner boundary    …

    Introduction This model describes the heat transfer between a body and a fluid flowing over or inside it as a result of the interaction of two objects. The physical processes and solutions of the governing equations are considered separately for each object in two subdomains.   In this problem, we have…

  PFI ENGINE SIMULATION     INTRODUCTION We are working on a Port fuel injection(PFI) engine simulation for Spark ignition(SI) on this project. We will be modelling our engine using spray modelling, turbulence modelling,combustion modelling and source/sink modelling giving reaction mechanism for combustion.…

Introduction In this problem we are going to setup shock across the square tube. We are going to obtain the pressure and temperature variation with time and also the cell count variation.   Setup Squarical tube is constructed by joing two tubes with an interface boundary. Two regions are separated by an interface…

LITERATURE REVIEW ON RANS DERIVATION AND ANALYSIS   1.  INTRODUCTION     Reynold’s averaged Navier-stroke equation is used to convert the Navier-stroke equation into averaged form to include the effect of turbulence into our model. Since the time scale of turbulence is very small, its not practical…

*********** Comments by Grader ************ GOOD JOB !!!! But where is an animation? Marks here are deducted for the above mentioned reasons. SUGGESTION : The other thing that you can do is to attach the code and images in projects.skill-lync.com  and paste the link over here.…

                                                   Fig 1 Geometry                                    …

OBJECTIVE: The main objective of this project to model an electric vehicle utilising diffrent blocks of Simulink and conclude the performance of vehicle.   MODEL PARAMETERS:                                          …

1. Maximum design taxi weight (MDTW) It is the maximum weight which is permitted for an aircraft on the ground for taxiing or towing purpose which is being constrained by aircraft’s strength Maximum design takeoff weight (MDTOW) It is the maximum weight which is permitted for an aircraft  when the brakes are…

INTRODUCTION: BJT H bridge(Bi polar junction transistor)- it uses 2 n type semiconductors and 2 p type semiconductors connected together forming H bridge with motor in between to control the speed and direction of DC motor. Diodes are connected in parallel with each transistor to allow passing of current in one direction.…

1.)  Popt- these are the cofficients of the polynomial function and will be calculated by our code as an output.       Pcov- The estimated covariance of popt. The diagonals provide the variance of the parameter estimate. To compute one standard deviation errors on the parameters use, i.e pcov…