All Courses
All Courses
Courses by Software
Courses by Semester
Courses by Domain
Tool-focused Courses
Machine learning
POPULAR COURSES
Success Stories
The objective of this challenge is to design a simple car model in Altair Hyperworks that will have a steering wheel, suspension springs, damper, body and wheels. This car will be used to run on a road that will be modelled with the vehicle using 3-D contacts. Each of the parts will be modelled as a separate subsystem.…
Mohammad Anas Imam Khan
updated on 24 Jun 2019
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Surface Cleanup Wind-Tunnel Setup and CFD Simulation of a Formula-SAE Car Running Over Two Different Tracks
The objective of this project is to perform surface cleanup, boundary flagging, virtual wind tunnel setup, pre-processing, CFD simulation and post-processing of a Formula - SAE Car below, the .STL of which was provided. The project has been divided into two phases: Surface Cleanup, Boundary Flagging and Virtual Wind Tunnel…
15 Jul 2019 07:05 AM IST
Study of Aerodynamic Flow Processes Around The Ahmed Body and Validation Against Experimental Data For a 35 Base Slant
Objective: The shape of a car body in-front of the largest cross-section has only minor influence on the total drag. The main contributions to the drag force originate from the rear part of the body. A drag breakdown reveals that 85% of body drag is pressure drag, most of which occurs at the rear end. The rest 15%…
05 Jul 2019 09:50 AM IST
Channel Flow Simulation Using Converge CFD
A channel flow simulation was done using Converge CFD Software for three different mesh sizes: 2e-4m, 1.5e-4m and 1.2e-4m respectively. The steps involved in setting up the case are mentioned below. Case Setup 1) A geometry for the channel is created 2) The necessary boundary conditions are defined. 3)The necessary steps…
25 Jun 2019 05:06 AM IST
Altair- Simple Car Model with Varied Elevated Roads
The objective of this challenge is to design a simple car model in Altair Hyperworks that will have a steering wheel, suspension springs, damper, body and wheels. This car will be used to run on a road that will be modelled with the vehicle using 3-D contacts. Each of the parts will be modelled as a separate subsystem.…
24 Jun 2019 04:10 PM IST
Related Courses
0 Hours of Content
Skill-Lync offers industry relevant advanced engineering courses for engineering students by partnering with industry experts.
© 2024 Skill-Lync Inc. All Rights Reserved.