3D Creation of Celing, Roof, Architectural plan, Structural plan, Sectional view, Elevation view and Camera specific view for a house plan using REVIT
1) Based on the project saved from Week 3, proceed from the First Floor Level. Model a Ceiling from the architecture tab above the walls at the first-floor level
A ceiling is created for both ground floor and first floor using ceiling option in archutectural tab and same material is assigned to these two roofs
2) Model a roof above the ceiling by selecting the footprints of the ceiling. Using the adjustment toolbars appearing on-screen adjust the roof slope to 10 degrees
A roof with 10 degree slope has been placed to first floor and a material is assigned to this roof using the roof by foot print option from architecture tab
3) Using the file saved from weeks 2 to 4, create plan views for ground floor level and first-floor level including all the walls, floors, and components. Separate them to
architecture and structural plans
a. Architecture plan must have walls, floors, and all the components placed within the building
b. Structure plan must have details of only walls, floors, and columns
Challange 2
Architectural plan
Ground floor
First floor
Structural plan
All the elements were created using architectural tab Hence there arent any structural elements here
Challange 3
Architectural
Ground floor
First floor
Structural plans
All the elements were created using architectural tab Hence there arent any structural elements here
4) Using annotate toolbar add dimensions to all the walls and floors with reference to the longitudinal and transverse grids created in the project file
a. The architecture plan dimensions include details on where the components are placed within the buildings with relation to grids. Overall dimensions are sufficient for architecture plans
b. The Structure plan dimensions must include details on the position of all the walls and interior walls with reference to grids. Locate all the framing components of the building with reference to a fixed point using Structural plans
Linear and aligned dimentions from annonate tool bar is used to assign the dimentions for both architectural and structural plans
Challange 2
Architectural plan
Ground floor
First floor
structural plans
All the elements were created using architectural tab Hence there arent any structural elements here
Challange 3
Architectural plans
Ground floor
Firsr floor
Structural
All the elements were created using architectural tab Hence there arent any structural elements here
5) Create a sheet template from the view tab and adjust the parameters on the sheet to add appropriate views
A sheet has been created using sheets icon in view tab
6) Using the elevation tab create the elevation views, looking at your building from East, North, South, and West
Existing elevation views are deleted and new elevations views have been created using elevation icon in view tab
- East
- North
- South
- West
7) Produce section cut through each room either cutting across longitudinally or in a transverse direction
A transverse and logitudinal section views have been created using sections option in view tab
Transeverse (Room section)
Longitudinal (Living room section)
8) Classify the views, Plan Views, Section Views, and Elevation views to either Design or Documentation category using Properties browser
All the views are classified in a specified pattern by the revit programming (can be seen in Project browser)
9) Using the sheet template produced create multiple sheets as follows
a. A 101- Ground Floor Architecture Plan
b. A 102- First Floor Architecture Plan
c. A 103- Roof Plan
d. S 101- Ground Floor Structural Plan
All the elements were created using architectural tab Hence there arent any structural elements here
e. S 102- First Floor Structural Plan
All the elements were created using architectural tab Hence there arent any structural elements here
f. S 103- Roof Framing Plan
All the elements were created using architectural tab Hence there arent any structural elements here
g. A-201- North-South Elevations
h. A-202- East-West Elevations
10) Create a camera-specific view or a 3D view in each room ( living, dining, bedroom). Based on the views create a new set of sheets starting A-501 (you can add as many sheets after, 502, 503.. n)to place the 3D view images. Produce the sheets as a part of project drafting.
