Objective:-                     To do a static simulation on the three different beams by considering them as a Cantilever Beam to compare the Stress, Displacement, and Strain in SolidWorks and to obtain the best Beam based on the Simulation results.  Case 1:-…

https://projects.skill-lync.com/projects/Genetic-Algorithm-using-MATLAB-to-calculate-global-maxima-of-a-stalagmite-function-76415

Objective: To Conduct a frequency analysis and apply a bearing fixture on the stepped face of the rod at the two ends and to find out the resonant frequencies of the rotating shaft. Rotating Shaft Design : The above shown model was made using solidworks and subjected to frequency analysis. Boundary Conditions:- Material…

Aim: To write a MATLAB program to parse the NASA thermodynamic data file. Calculate thermodynamic properties of various gas species. Plot the Specific Heat(Cp), Enthalpy(H) and Entropy(S) for the local temperature range specific for each species. Theory: 1) Parsing Parsing a file means reading in a data stream of some…

Objective To simulate the forward kinematics of a 2R Robotic Arm using MATLAB Theory Robotic Arm A robotic arm is a type of mechanical arm, usually programmable, with similar functions to a human arm. The arm may be sum total of the mechanism or may be part of a more complex robot. The links of such a manipulator are connected…

Objective:-                    To do a static simulation in a plate with a single hole and with three holes in SolidWorks to obtain the stress, strain, and displacements and to compare the results. Modeling:- The plates are modeled with the specified dimensions in SolidWorks. …

Aim To optimize the stalagmite function and find the global maxima of the function. Theory Genetic Algorithm(GA) is a search based optimization technique based on the principles of Genetics and Natural Selection. It is frequently used to find optimal or near optimal solutions to difficult problems which otherwise would…

Objective:- To write a code in MATLAB to plot the PV diagram for Otto cycle and calculating the thermal efficiency  of the same. Theory:- Otto cycle is the thermodynamic cycle which forms the basis for the working for spark ignition engines. The processes involved in the cycle is described in the below figures. Inputs:-…

https://projects.skill-lync.com/projects/Parsing-NASA-Thermodynamic-Data-Using-MATLAB-04391

Overview This project aims to create code for calculating drag force over a cyclist. Drag Force is the resistance force caused by the motion of a body moving through a fluid,such as water or air. Drag Force is given by `Fd = Cd cdot frac{1}{2} cdot rho cdot A cdot V^2` where  `Cd`= Drag Coefficient `rho`=…

Aim:- To produce the curve fit using MATLAB and to determine the best fit to predict the data Theory:- Curve Fitting is the process of constructing a curve or mathematical function that has the best fit to a series of data points possibly subject to constraints. Curve fitting can involve either interpolation, where an…

Aim: - A program to simulate the transient behaviour of a simple pendulum and to create an animation of its motion. Sub Objectives:- Write a program to solve the ODE Plot the displacement v/s time & velocity v/s time graphs Create an animation of the motion of the pendulum Theory:- In Mathematics, an ordinary differential…

Objective:- To use solidworks simulation tool to observe the buckling characteristics of a cyclonic separator stand.  To add a stiffener to the legs of the stand and determine the increase in critical buckling load. To use solidworks parametric design study to run parametric simulations and obtain the optimum position…

https://projects.skill-lync.com/projects/Second-Order-ODE-Solving-For-Pendulum-Motion-84216