Drive link: https://drive.google.com/file/d/1YtGO9F3cTDQ_99qN3soxP9m27JD9DPee/view?usp=sharing  Hood Design using CATIA V5 A car hood is also called as a bonnet. It is the important component of front portion of car. Its main function is to provide direct access to the engine, battery, radiator and other crucial parts…

Introduction In British English, the fender is called the wing, this may refer to either the front or rear fenders. However, in modern uni-body vehicles, rear fenders may also be called quarter panels. In modern Indian and Sri Lankan English usage, the fender is called a mudguard. Fender is the part of an automobile,…

Introduction Roof of an automobile sits above the passenger compartment. Roof houses the vehicle as a shielding part, which safeguards the occupants from sunlight, heat, rain, wind, dust and other external elements. In case of convertibles, it is called the hood. In the past roof was introduced as cover for passenger compartment…

Introduction Back door is the rear most part of a car. It gives access to the rear storage compartment of the vehicle. It has to be strong enough to sustain the rear crash. Back doors are made from steel/aluminum panels that swings (moves up or down during loading and unloading) with the help of a hinge mechanism. Back…

Figure: 1 Solid model of Butterfly valve body Thus the butterfly valve body is modeled Figure: 2 Drafted with applied GD&t   Figure: 3 Solid model of Shaft Thus the shaft is modeled Figure: 4 Drafted with applied GD&t   Figure: 5 Solid model of Retainer Thus the retainer is modeled Figure: 6 Drafted with…

The Yacht consists of the following parts Hull Garage door Superstructure Radar Radar mast Propeller Front, Middle and Rear seat   1. HULL Hull is the base of the yacht and it is symmetric model. So one half is modelled and the other half is mirrored. Initially hull is created in surface model, then after completion…

1. Transmission Belt Commands used: Line, Smart Dimension, Off-set Entities, Extruded boss/base, Fillet. Step 1: Front plane is chosen for sketching the profile is drawn. The profile is constrained by providing dimensions and relations. After the sketch is drawn, we exit the sketch. Figure shows: Sketch of the…

Introduction                 When viewed from the top side of the vehicle, the tire should not protrude outside the fender. Because if it protruding outside would lead to more chipping while driving and have to compromise in pedestrian safety. Therefore,…

Material of the hood: Stainless steel AISI 302- cold-rolled, Y = 520 Mpa Section Modulus: Section modulus is an important factor for beam and flexural member design. Higher the section modulus, higher will be the resistance to bending. It is easier to calculate stresses in beam and an exact measure of strength of steel.…