Wiring harness routing & packaging Rules Week 3 Challenge

REPORT:

P CLAMP: the p clamp was downloaded from the website and checked it for the compatibility . after that in tthe part design the parameters are given a point is made in the entry point and a plane is created at the point parallel to the surface after that a point is mad at the other end which is at athe exit. and a plane is created parallel to the surafce. and a base is created at the base of the p clamp. after that go to the electrical workbench to define the electrical components. by using define support option defined the pclamp as a electrical component.

BACK SHELL: the back shell cad data was downoaded from the website and checked for the compatibility. after that the cad was put into part wprk bench for defining the parameteres. a point was created at the mating part of the component. after that an axis is created at the point. the y direction is set to coinciding area and x is set to the locking region and z is to the left and right direction. after that jump into the electrical workbench for defining it as an electrical component.by using define back shell comand defiend the backshell as an electrical component.

CORRUGUTED TUBES: corrguted tube was created in the electical part workbench by using the command define protection part. by clicking that a window will open there we can give the required inner diametre,outer diametre,thickenss of the tube and the bend radius. after creating the tubes we need to create a new catalouge for the corrugutter tubes ,so thwt that we can access it easely