Wiring harness routing & packaging Rules Week 3 Challenge

P_CLAMP:

The clip is a support part in the electrical part family.They may or may not be available in standard.To define a clip following steps has to be follwed:

1. Download the part
2. Define the part as support
3. Add the geometrical parameters
4. Define the entry and exit point for the support
5. Define the base plane 

CREATE GEOMETRICAL PARAMETERS

DEFINE AS SUPPORT

DEFINE THE ENTRY POINT

DEFINE THE EXIT POINT

BACKSHELL:

To define the Backshell the follow the below steps:

1. Download the part
2. Create the gemetrical parameters (point and backshell axis)
3. Define the backshell connection point
4. Defone the bundle entry point

DEFINE THE PART 

DEFINE THE BACKSHELL AXIS 

DEFINE THE BACKSHELL CONNECTION POINT

DEFINE THE BUNDLE ENTRY POINT

COT TUBES:

COT TUBES/CORRUGATED TUBES/CONVOLUTED TUBES CAN BE DESIGNED BY USING DEFINE PROTECTIVE PART COMMAD IN ELECTRICAL PART DESIGN.ALL COT TUBES ARE SAVED IN SLIT_COT CATALOGE AS SHOWN BELOW:

TO DEFINE THE NEW COT TUBE

ENTER THE VALUES TO CREATE COT TUBES

5MM_COT

10 MM_COT

15MM_COT

20MM_COT