Week 9 - Project_1 - Door Trim Lower with Engineering Features

Week 9 - Project_1 - Door Trim Lower with Engineering Features

Challenges Submission

REPORT ON CREATING TOOLING AXIS

Since the begining of Dlastic Design, the concern engineer mention that creation of Tooling Axis is much convinient on a big flat surface or a circular cutout which is available on the design.

First we need create a point which will be good to create the Tooling Axis,

then we extract the boundary(outermost) for the references of creating line, after creating the line we create another line by choosing the option Bisecting, then we create a line bisected from the reference we created earlier.

After the creation of the line, we choose the line and Click on Normal View,

if the normal view show all the corners and visible part properly, then we know that the Tooling Axis that we create is Correct.

Draft Analysis

Draft Analysis the way of checking the design which we created, to ensure that the draft that we created is properly maintain or not

After the design we go to Feature Draft Analysis available in the Toolbar (Analysis Option)

Then we drag the compass and put in on the Tooling Axis created before and click where a red cross is appear,then it will appear the require information along with colours as well as 3deg, 0deg and none

(This my fisrt time creating Report and if there's mistake kindly point out the mistake and give me the chance of rectifying mistake)