Week 9 - Project 1 - Door Trim Lower with Engineering Features

AIM; THICKEN THE DOOR TRIM, ADD TWO AND FOUR WAY LOCATORS AND HEAT STAKES ACCORDING TO THE DESIGN RULES AND VERIFY WITH DRAFT ANALYSIS. COMPLIETED DOOR TRIM; WE WERE PROVIDED A CLASS A SURFACE AS BELOW WITH LOCATIONS FOR HEAT STAKES. DOOR TRIM WITH HEAT STAKE POSITIONING; WE THEN CREATED A MAIN TOOLING AXIS USING POINT TO DIRECTION LINES AS BELOW. THE MAIN TOOLING AXIS WAS CREATED ALONG THE Y COMPONENT. THICKENED PART; AFTER CREATING THE TOOLING AXIS WE THEN THICKNED THE DOOR TRIM BASED AN THE COMPLETED DOOR TRIM CLASS A,BAND C SURFACE. WE NEXT ADDED TWO FOUR-WAY AND ONE TWO WAY LOCATORS AND FIFTEEN HEAT STAKES ACCORDING TO THE RESPECTIVE DESIGN RULES WITH THICKNESSES OF 1MM AND HEIGHTS OF 20MM RESPECTIVELY. BOTTOM ISO; THE DRAFT ANALYSIS AS SHOWN ABOVE VALIDATED THE DESIGN FOR MANUFACTURABILITY. CONCLUSION; WE WERE ABLE TO SUCCESSFULLY MODEL THE THICKENED DOOR TRIM WITH LOCATORS AND HEAT STAKES AND SUCCESSFULLY VERIFIED THE COMPONENT FOR DRAFT ANALYSIS.