Week 9 - Project 1 - Door Trim Lower with Engineering Features

AIM

To create the door trim lower component from the given class A surface and create the engineering features ( heat stakes and locators ) on the component.

Objective

To create the tooling axis.

To create Class B and class C surfaces .

To create the plastic component.

To create the heat stakes and locators .

To perform the draft analysis .

Creation of tooling axis

Initially check the propable direction for the tooling .

After finding the propable direction extract the flat surface from the class A surface.

Create the center point on the extracted surface .

From that point create on perpendicular line to that surface this is our tooling axis.

Draft analsysis on the class A surface .

Draft analysis on the final component

Final product views

Conclusion

The final plastic component from the claas A surface is craeted and also the engineering features are also develo[ped on that body . Then the draft analysis also performed on the both clas A and final product.