Week 9 - Challenge 2 - Switch Bezel Design
Report on draft analysis
Draft analysis is the key of finding each inclined surface angle each angular geometry can be define and check by using draft analysis.
Draft analysis can be done on a specific tooling axis which is created by a different types of method.
Mainly there are two types of method which is creating a tooling axis as mention;
O1) Bisecting method
02) Surface point method
As tooling access successfully done by above mention two methods
After creating a tooling Axis draft analysis to be carried out step by step
To entering in a draft analysis, click on a feature draught analysis which is present in analysis option.
After we open the draft analysis menu they will shows mainly three parameters;
1) Mode
2) Display
3) Direction including with Information;
The first process of draught analysis is to set the compass to the Tooling axis as earlier we have created by describe method;
Compass is situated in the direction parameter of the draft analysis Menu
After click on compass tab just move the compass on from screen to the tooling access and then locket same situated in the direction tab.
And then we can check by just clicking on the part body or any surface of the Design.
If it is shows blue then it shows in inverse mode to make it correct by just click on Inverse tab same as mention in the direction parameter then it will be green.
Draft analysis menu are another parameter like mode and display
In a more parameter we can just adjust a colour coding of below the 3 degree above the three degree of zero degree and so on.
And another mode has carrying a feature of their detailed colour coding which is we are conducted by just setting there angles below above and within a range it can be shows in the mode parameter of draft analysis
In a display in the display mode there are a number of parameters present as there are conduct a colour scale analysis under the running point there are also shown in light effect and no highlight representation there are four options are mostly useful in their complicated designs and moulding effects.
BISECTING METHOD FOR CREATION OF TOOLING AXIS :-
1) We need a two intersection of creating a bisecting line
2) First intersection by creating a line which of YZ plane.
3) Second intersection by creating a line which of ZX Intersection, as we have no other surface so take 3 Degree of reference surface alone to their plane.
4) Finally by using LINE Command select bisecting line and select line 1 of first plane and simultaneously line 2 of second plane., then the TOOLING AXIS IS FORMED.