Week 9 - Challenge 2 - Switch Bezel Design

DRAFT ANALYSIS : Draft analysis option should be selected from the insert > analysis > feature draft analysis before that material shading should be selected from customise section of shading toolbar. Now after opening feature draft analysis select the surface and select and set compass to the tooling axis , set the mode to quick analysis and set draft value to 3 degrees

TOOLING AXIS: Tooling axis is created using the intersection method by first assuming the dummy tooling axis such that the major flat areas or any holes should be clear in the main tooling without the need of side cores.Here in this part it is selected on the basis of large flat areas and one way to cross check it is that upon normaling part as per tooling axis every surface should be visible.

NOTE: catpart file along with all the screenshots has been submitted through compressed RAR file.