Week 9 - Challenge 2 - Switch Bezel Design

Process of finding Draft Analysis and Main Tooling Directions.

1. For draft analysis, firstly the Center of Gravity is taken for the given surface.
2. A point is obtained which is also called as C.G. point at the center.
3. Then a line is been create on the same point i.e. C.G. point on Z-axis which denotes the Main Tooling Direction or Tooling Axis.
4. Then the compass is adjust on the main tooling direction.
5. Then go to the Part Design and select the option draft analysis.
6. As per the variation in colour code, we can easily determine the draft analysis.
7. If the colour code shows Green, it means the part is clear and the parameters are suitable for draft analysis as per set standards.
8. The red colour code on part denote zero draft or negative draft also called as Undercut.