Week 9 - Challenge 2 - Switch Bezel Design

Helllo Sir/Madam,

I have created Switch Bezel design challenge as requested & submitted Presentation & Data in Zip file.

Please check & let us know if I need to do any modification in any area or in draft analysis ir in tooling direction.

I have a query about this, in session tutior said that we wont give parting line towards A side if surface.

Now While giving draft inside from A surface to C surface. we indirectly making out Parting line on side of A -C surface merging. So, do we have this general rule to give darft inside.

or we set draft outside & create Parting line on B & C surface merging.

Let me know your comments. so i get clear idea.

Thank you & Best regards,

NIKHIL KHAPRE