Challenge

Week 9 Challenge

OBJECTIVE

Run the cool analysis by using normal and chiller circuit of ruler geometry.

PROCEDURE

STEP 1: command used to build the ruler geometry

1. nodes

2. beam

3. region

4. curves

STEP 2: RUN THE DUAL MESH

Set as a parameter as Global length of one 1mm, the ratio of the edge length of 0.75, the ratio of the edge length of the diameter 2.50.

STEP 3: Select the sequence analysis of cool, fill, pack, and warp to know the behavior hoe mold act in the mold.

STEP 4: Select the material of LEXA 940 SABIC by going down the option below, as per requirement.

STEP 5. Coolant inlet

STEP 6 Process control

Set as melt temperature 301 deg, open mold time 3 sec.

Filling control: set as an injection at which the part is feasible so that according to calculation it's 1.7 and 98 % volume filled.

holding control profile:

Cooling analysis comparison b/w normal cooling and using a chiller cooling and over packed.

1. Circuit coolant temperature.

as recorded 60.00 in chiller and 60.31

less temp has been recorded in chiller temp is 57 deg

Conculsion

we should go with chiller circuit better than normal coolant circuit.

Ship work like this
in your own course.