Week - 8 - Morphing

Week – 8 Morphing

Morphing is change the design and shape of any component without using any numerical units.

For morphing we need to create morphing box. For creating morphing box we need to go to morphing deck in boxes we need to select new> select should be geometry and box type will be min volume.

Then we need to select geometry where we actually want to create morphing box. After whole selection we need to give middle click to confirm box.

After that we need to select move in box morphing section than select the nodes where we want to move the geometry and right click on any edge to get direction with coordinates, based on the coordinates direction we need to switch off/on the particular direction to move freely.

We can move freely until we confirm by left click and exit by middle mouse button click.

• Morphing can be don on cad as well as FE model.