Week 8 - Challenge 4 - Bumper

1. TOOLING AXIS CREATION :

I CREATION THE TOOLING AXIS IN THE FRONT DIRECTION USING NUMBER PLATE, WHEREI CAN SEE ALL THE SURFACE ACE WITHOUT ANY HIDDEN SURFACE WHILE EJECTING PART FROM THE MOULD IT WILL COME SMOOTHLY BY USING THIS DIRECTION.

2. DRAFT ANALYSIS :

USING THE TOOING AXIS I GHAVE DONE THE DRAFT ANALYSIS, I HAVE SET RED COLOUR FOR DRAFT ANGLE LESS THAN 0,BLUE COLOUR FOR DRAFT ANGLE BETWEEN 0-3 AND GREEN COLOUR FOR DRAFT ANGLE MORE THANE 3.

1 . CLASS A SURFACE DRAFT ANALYSIS :

2. FINAL DRAFT ANALYSIS :

3. A CLASS SURFACE :

4. B CLASS SURFACE :

5. FINAL B CLASS SURFACE :

6. C CLASS SURFACE SWEEP CREATION :

7. A+C CLASS SURFACE :

8. FINAL TRIM :

9. SOLID PART AND ISOMERTIC VIEW :

10. BOTTOM SIDE VIEW :

11. FRONT SIDE VIEW :

12. TOP SIDE VIEW :

13. 4 POINT VIEW :

14. FULL BODY BUMPER :