Week 8 - Challenge 2 - Switch Bezel Design

According to the the given challenge the tooling axis is made by bisecting methord the first step in ploting the point on the base surface then the axis system is place on the point. the intersect 3D element command is use to the get the outer line of the class a surface. biasecting line are use for two plane to get the biasecting line after ploting two line we have applied the biasecting line and then trim the biasectiong line to the required length.

then we have multiple extract for the require for the surface then unitrim the given surface . offset and trim the the all surface seperately and joint the given a surface with the c surface and again trim the joint into b surface . we have finally made the closed surface into the solid surface