Week- 5 - Solid meshing

Aim - To create volume mesh for closed volume gepmetry by using tria and ortho tria.
Steps-
1.First i have done topological cleanup for the geometry.
2.By using one by one sub geometry i have checked for geometry checks.
3.For that I used AUTO CHECK to remove all the errors from the geometry.
4.After removal of errors it shown the 0 errors that menas topological cleanup has done.
5.After that I have assigned the SET PID to differentiate the each sub component.
6.Next i have given quality paramaetrs like min and max lenght.
7.Assigned taget lenghth in MESH PARAMETERS and used MIXED mesh type so that i can use tria and ortho tria whenever necessary.
8.I have given mesh for the geometry whenever tria and ortho tria required by using MESH MODULE like for the plain surface tria and for inclined surface ortho tria.
9.To remove offs used reconstuct and smooth feature so that get a better result
10.In that I checked for kinks and raised edge formation and tried to eliminate.
11.After that I used VOLUME MODULE to given Volume mesh for that closed volume geometry.
12.First I define the each geometry by define feature in volume button.
13.After give TETRA FEM to mesh the volume in UNSTRUCTURED BUTTON
14.After completion of volume mesh it shown the volume as TETRA FEM MESHED it means volume mesh has done for the geometry.
Conclusion-For the closed volume meshing there is no kinks and raised adges should present that is why used tria and ortho tria mesh type