Week- 5 - Solid meshing

Geometry cliing

In this challenge first I check how many different parts are there with help of PID

Then after turn on only one PID at time

Preform topo then check geometry

If any error generates then solve it

In one part there are two Triple cons identify

Then release cones and we found a small face there so I delete small face and preform topo

Then check geometry again

Preform same process for all the parts

Generate surface mass

Switch to mass

Set perimeter length to 1mm

Set quality criteria and mass type (tria and ortho trai)

Generate surface mass with help of spot mass in individual faces

Convert to hidden mode for quality fail

If quality is failed then solve it

With help off improve mass, move free and perimeter number change

There is some face witch total length is minor smaller than minimum length

So, I move nodes with help of move free

Generate solid mass

Then define volume and set PID with PSOLID card

Generate unstructured mass using tera FEM

Then check quality fail

New thing to learn

How to sprat different part using PIDs