Week 5 Challenge : Surface wrap on Automotive Assembly

Aim:

For the given models, check for the geometrical errors and delete surfaces which are unwanted for Surface wrap as shown in the videos. After clearing geometry, Merge all 3 models and perform surface wrap.

Objective:

Target length for Wrap = 3 mm
Write a detailed report on steps followed to finish this challenge.

Conclusion:

Hence we have generated the surface mesh on the geometry of the engine with transmission and gearbox.

And hence also checked for the given models, check for the geometrical errors and delete surfaces which are unwanted for Surface wrap as shown in the videos. After clearing geometry, Merge all 3 models and perform surface wrap. As shown above images.