Week 5 Battery characteristics using drive cycle

Steps

Import the data using excel file to signal builder block (Time & current profile). Connect output guide to input of CCS. 

Select current source from block library and make sure block arrorw sign towards down for discharging battery. Connect guide to battery + & _ terminal with battery opposite + & _ terminal. It convert simulation signal into an equivalent current source.

Battery output is connected to Bus bar input where bus bar have SOC, Volatage and current selected and then finally connected to scope for output and then further can be viewed in scope layout.

 Output SOC decreases from 100 to 99.9983.

Current raised to 0.05 and then plummetted to 0.03

Voltage dropped from 8.4116 to 8.4108.

This output is based on UDSS sheet  Time & Current.