Week 4:- Pin Unit Design Challenge

Fundamental of pin unit design

1. Pin should engage 3 to 5mm from car panel entry surface.

2. All pins should be accomodated with 2 way adjustable shims irrespective of direction of arresting.

3. Round pins should be used in case of 4 ways arresting of car part if the hole is round.

4. Round pins can be used for two way arresting of car parts only if the hole is slot.

5. Diamond pins should be used in case of 2 way arresting of car parts if the hole is round.

6. Diamond pins should be used in case of 4 way arresting of car part if the hole is slotted.