Week 3 - Geometry simplification of an Electronic enclosure assembly

1.Remove unwanted parts by using split by body.
2.Remove all unwanted bolts,nuts and washers
3.Delete all the fillets and chamfers
4.Delete all the bolts holes
5.Remove small capacitors parts which not make any difference in results
6.Make sure there is no intersetions between two parts
7.if any intersections move parts to mainatain least 0.5 to 1mm
8.Convert the parts into icepak bodies by using different simplification method.
9.Save file as icepak project.
10.Open the model in icepak
11.Check the model in icepak