Week 2 Challenge
AIM:To create the simply supported and fixed beam by using the given load condition and spans.
INTRODUCTION:STAAD pro is used for structure analysis of structure by using the shear force diagrama and bending moment diagram.
PROCEDURE:
1.1
ANS:
Open the STAAD
In analyatical model,properties then define the shape (circular) and assign.
1.2
ANS:
Open the STAAD
In model information select the units(metric) then create the model.
1.3
ANS:
Model name
Length
height
Width
No of bays along length
No of bays along height
No of bays along width
1.4
ANS:
STEEL-AISC360-16,AS4100
CONCRETE-ACI318-2014,AS3600
ALUMINIUM-Aluminiun US
TIMBER-AITC-1984,AITC-1994
2.1
ANS:
The following are the inputs units in STAAD pro
Geometery
Properties
Specificstions
constants
supports
loads
load combination
Design standards
2.2
ANS:
Fixed-Degrees of freedom are consider as fully restarained,when displacement is zero degree of freedom is not consider for stiffness.
Enforced-Degrees of freedom are consider as fully restarained,STAAD assigns sprigs for stiffness.
3.1
ANS:
Creating the file
Select the units
Use the geometry by nodes
Assign properties,material.
Then perform analyisis
Then assign the design code.
Then perform the post processing for out put view.
3.2
ANS:
Node by node
By structural wizard in geometry tab.
3.3
ANS:
Fixed
Fixed but
Multi spring
Only spring
Inclined
pinned
enforced
enforced but
3.4
ANS:
By node dispacement design the slab.
By using generate mesh create the plate to the design.
Stress distrubution is done by colouring the slab
3.5
ANS:
After the analyisis,post processig in result tab cooridinatinates are there like,Fx,Fy,Fz,Mx,My,Mz.
After the analyisis,post processig in result tab graphs are there in layout options