Week -2

As per the given simulink dorebell model conditions,the following blocks were used

*Pulse generator

*Switch

*Battery

*Solenoid

*Ideal translational motor sensor

*Mechanical Reference

*Electrical Reference

*Scope

Pulse Generator It was used to create square wave pulse at regular intervals also it can include phase width,amplitude,phase dealy and all that are convient for the conditions given,

Switch This was controlled by external physical signal(ps).If the external physical was greater then the switch is closed other wise it is opened.

Solenoid The c and R ports of the solenoid are connected to the ports of the ideal translational motion sensor.

The signal from the pulse generator was converted using simulink ps converter and scope is attached to it to read the variations.The position of the solenoid was measured using ideal motion sensor.

One end of the battery circuit was connected to the electrical reference.The whole system was connected to the single solver configuration.

The ideak motion sensor was converted into simulink model using ps simulink converter.Than it is connected to scope to see the observations.

In the pulse generator block paremeter all the input conditions was given and it is observed by using scope block.