Week 14 challenge

REPORT:

I assembled all the parts that i have created individually and applied GD&T.

First a flatness of 0.25mm was applied to the specific part of the surface and datum A was given, to reduce the cost of production. And perpendicularity of 0.25mm tolerance was applied and asigned as datum B. position tolerance of 0.25mm was applied to the feature and datum C was given. And another tight position tolerance of 0.5mm was given and datum D was asigned. Though it has two sets of holes a postion tolerance of 0.75mm was applied on all three of the holes. A surface profile of 0.25mm was appiled to the surface.