Week 10 - Challenge 3 - Door Trim Lower with Engineering Features

Detailed Report -

1] Creating a Point

2] Create a line by using point direction method

3] Create a B- surface where give 2.5 mm of offset

4] Create a C-surfcace where done sweep & extrapolating opertion

5] join class A & C surface by using join command

6] Make the closed surface

7] Did the final Draft Analysis Report for draft analysis give 2.9 degree celsius.

8] Creating a HEAT STAKES

9] Create Normal to curve plane

10] Create a sketch of hole 7.5 & 5 mm for heat stake

11] Create a locators 4 way type & 2 way type

12] Did the Draft Analysis Report for HEAT STAKE give 0.45 degree celsius.

• Screenshots of the completed design in various orientations (Isometric, Front, Side, and Top View) -

Isometric View -

Front View -

Left Side View -

Right Side View -

Top View -