Week 1- Mixing Tee

Momentum ratio = velocity at cold inlet/velocity at hot inlet

Geometry:

First, select Fluid Flow(Fluent) to make a simulation setup.

1)Import geometry from g drive long and short pipe.

2)clicking the edges from where the fluid flow is in contact during the simulation, removes the unwanted geometry volume by clicking the tick mark at the left bottom of the main window.

3)Then, unbox the shell by clicking the tick mark in the shell so that geometry that doesn't have a role to play during simulation is removed.

4)Then right-click the shell and select suppress for physics.

5) setting up all cell zone boundary conditions and initializing the problem by iteration solver (100-250).

6)By getting results and contours post-processing will be done