Challenge

Tool Test 1

Time to taken: PART-1 -6 hr and part-2 -3 hr

Aim:

To perform the mid surface extracting and 2d shell meshing of the given component and obtain the 100% quality certeria and assign the proper thickness of the component

Quality certeria

PROCEDURE OF MID SURFACE EXTRACTION:

STEP:1 IMPORT THE MODEL AND VIUALIZE THE 2D TOPO
STEP:2 CLEAR THE ALL FREE EDGE BY USING THE CUT,RELEASE,DELETE IN HOT POINT AND CONS
STEP:3 CHECK NO FREE EDGE & 3 SURFACE ASSOCITATED SURFACE LINE
STEP:4 USE MID SURFACE APPRAPERIATE SELECTION METHOD
STEP :5 CHECK ANY SURFACE GILITICHES ARE FOUND AND CLEAR IT

CHECKING THE MODEL IF UNIFORM THICKNESS OR NOT

Before gone to take mid surface you first check the model by check manger
After check manager gives a green signal we check the given model is uniform thickness or not. it done by measurement between two nodes.for measurement of node go to measurement>node>
After measuring the various area of the component we decide the given component are non uniform thickness so, we do the manual offset method for the mid surface extracting
same like this we measure the thickness between various two surface and extract the manually

Model feature capturing

in above image feature capturing before and after image
in above image feature capturing before and after image
in above image feature capturing before and after image
Final mid surface of model
After the completing the mid surface create lock view of mid surface as shown image and orient surface in out side is gray

Procedure to mashing the component

Once mid surface is coompleing means the next step is Discretization. dividing the big structural into small small piece as name of node and element
First upload the certria file as question mentioned press F11
meshing is not carried out by singel shot it make more trias and faling elements also it very deficulty possiable for rectifying the error elemts
meshing always do the surf by surf it make good flow and reduce the error elements
after the complete the mesh the mesh look given below
After meshing completed we have to create the property by using the key Ctrl+P and assign the orignal thicknes of the surfaces
then to view the assign thickness go to the F11 and select shell soild
IN THE SAME WAY ALL PERFORMANCE IS CARRIED OUT IN PART MODEL ALSO

RESULT and learning out comes

In this assignment welearn the various technique of midsurface extraction, shell meshing,quality fixing and mesh flow allignment
Model evaluation Requirements- Proper Mid surfacing, Good Mesh Flow, No OFF elements, Thickness Assignment
model with and without Topo cleanup, FE model with and without enabling thickness, checks, etc

Ship work like this
in your own course.