Project - Analysis of a practical automotive wiring circuit

1. ignition coil, distributor, breaker, starter, battery , generator, current and voltage regulator , ON switch , ammeter , junction block , fuse, foot selector switch.

2. ignition coil is used to ignite the fuel which will give the power for the piston to run the engine

Battery is used to start the engine initally to make the engine run

distributor is used to decide at what time which injector should spark and it decides the firing order of the engine

3. 20A

4. 12V 180Ah

5. plate light and gas tank unit are in parallel because if one breaks down also others will properly without any disturbance.

6. tail light and tail stop are connected in series because the current flows through both the loads are same