Project 2 - V&V SW Analysis II

NOTE: Due to the LDRA Tool Liscence issue the Challenge is submitted in test steps with no output attachments

//01 Creating a Sequence and conducting Static COde analysis testing.

1. Open the LDRA Launcher. Invoke the TBrun tool.
2. Load the source file(single file) from the defined path.
3. Say yes to the static analysis promt and complete the analysis part
4. Create a new Sequence testing mode.
5. Create a test case for a function (check the procedure Code) and add the appropriate input values under the VALUE colum in IO view.
6. Create STub functions if needed.
7. Source :- Generate the driver Code for the test case.
8. Source:- Build Driver (to compile the code with the selected compiler and generate the executables)
9. Source:- Execute the Driver code.
10. Source:- Proccess the Driver output(To check if the test passed or failed)
11. Check the Regression Reports from Results Tab
12. Reapeat the above steps for remaining functions.
13. Generate the Code Review Report and analyze.

//02 Creating a Sequence and conducting Integration testing.

1. Integration testing is the phase in SW testing in which SW modules are combined and tested as a group
2. to perform integration testing on all the files in the Cashregister_6.0
3. Select source , select multiple file create a file add the required .c files for testing and create file
4. Cashregister.c,userinterface.c and main.c are chosen for testing
5. Stub management is done by creating sequence
6. Static code analysis id done and result is obtained from test manager report
7. White box testing is done for multiple files
8. Testing is done by selecting run extreme tabular test
9. Regression report, Dynamic coverage test report is analyzed
10. Generate results for:
    1. the Static Code review
    2. Stub management
    3. Blackbox and white box testing
    4. Extreme tabu;ar test report
    5. .tcf file generation
    6. test case excecution
    7. completion of Integration testing