Project 2 Adaptive Cruise Control

ADAPTIVE CRUISE CONTROL

Note: My licence is expired i purchas student vession this vession dont supported embedded coder please accept the design with out code .

Requirement 1:

*. Note: My licence is expired i purchas student vession this vession dont supported embedded coder please accept the design with out code .

*.Note: My licence is expired i purchas student vession this vession dont supported embedded coder please accept the design with out code

.

Requriment :2

*.The above iputs like same drive vehicle camerainput_drivevehicle and RadarInput_DriveVehicle taken inputs and one input as add in subsystem name is Accelration_Mode.

*.total 3 inputs inthe requriment 2 and 2 out puts are they are drivaVehicle_speed and LeadVehicle_Detected

*.Diffence upone speed and detection of load vehicle in sensor senssing

Requriment :3

*.Adaptive cruise conterol mode as used in major 3 parts they are one is OFF mode secound mode is STANDBY mode Last one is ON mode .

*. This subsystem are 5 inputs are used they are Time_gap, set_Speed< Set_Gap, Cruise_Switch< Set_Switch.

*. they are out put in this subsystem are ACCELRATION_MODE . They are drive vehicle governs the automatically adjust the speed .

*.Inside subsytem they are used CHAT algorithums are used tey are OFF condition and Standby condition vehicle and ON mode VEHICLE conditions are used in this CHAT block.

*. after design the logic after link data dictionary attached model block solver settings added and after we run the program and finally genrate the embedded code and run the program . its show final resuls .

*.THE FINAL RESULTS WAS equal to 1 STANDBY MODE activated, if equal to 0 ACC OFF MODE activated , either ACC MODE ON and STANDBY MODE activated.