Project 1

Project 1:

The Cad provided is an IGS file without any history. It is front-row back foam. Use Under build / Over build technology. Make use of the foam terminology. Make foam parametric and use standards for making the parts.

1 – The Complete design should be parametric.

2 – Use Best Practices as Explained.

3 – Use of best practice and maximum use part design.

 

                                                                                                                 

 

The Cad provided is an IGS file without any history. It is front-row cushion foam. Use Under build / Over build technology. Make use of the foam terminology. Make foam parametric and use standards for making the parts.

1 – The Complete design should be parametric.

2 – Use Best Practices as Explained.

Estimated Hours to complete the Part: 9 hours 

                                                                                                     

 

Making of the seat back: 

In this case, we've got provided with a dump solid of the seat back and headrest so we'll have to create sto then we'll have to create the solid foam so for that I extracted the surfaces of the dump solid and repaired some damages over the surfaces then I've created sto

 

 

      

Creating H-point:

To create the H-point I've created a point over the curve then I've created lines from that point in 40 mm length and 20 mm height 

                                           

After that i created multisection surface for the back side

Making of wings(BOLSTERS):

So in this case I've followed a different type of approach which contrast to other approach shown in the video, So, what am i done is I extracted the surfaces of the BOLSTER'S.

I Make the sweep command to create the bolster and offset it and I trimmed the bolster using the Trim command. 

                                 Then I begin to create the top and bottom surfaces first I extracted the top surface then took a boundary and extrapolated then I trimmed them together and the same thing I've done for the bottom surface as well.

                                                                       

                          

Making of seat lower part:

Then whatever methods I followed for creating seat upper part same thing I applied for the seat lower part as well

     

STO:

              

Surface body:

          

Solid foam:

                  

Solid foam:

                 

Making a solid foam from Unproper sto:

Given data:

                                                                            

making of the top and side surfaces using the sweep command.

three guide curves method

Trim all surfaces using trim command.

closed part body:

Trenches for all body: