Hood design-Week 2

Report of HOOD DESIGN

as the data is given first we have to analyze the master section properly so no mistake should not be thr then we have to now we have to start with design and first is hood design and striker and hinge is give it is just we have to assembly it

HOOD DESIGN

first which design is given first we have to select it and transfer to another geometric set then we have to create another working file and give and offset of 1.7mm towards below direction of outer pannel and

• Then create a scetch with zx direction then there will be offeset of boundary command select and give a distance of 20mm inward direction direction then come outside then give a projection on surface body and with trim comand select sketch and element to cut surface body and trim inwards direction
• Then with the same method other surface should be created and with distance of offst of 20 and 25mm distance and triming boundary should be distance of one 22 mm distance and 50 mm distance then after with the help of projection we have trim in ward direction
• now we have to interlinck all the surface with the help of multi section surface but for that we have to creat boundary on all the surface which has to be connected and then with the help of multi section and the fillet should be given 3 to 5mm but
• and apply it on half hood surface then we have to embossis in lower surface with 8.5 mm of hieght and as we know we have to make a sketch and then with the help of trim and remove with surface with and then keep the draft angle of 7 degree and then and the upper surface should be of 8.5 and and should be fillet of 3 of 5mm
• then we have to create hinge mount of of surface we have to create it of 15 mm and then then we have to create symmetric and then join the surface
• then we have to create stiker mount then we to take axis from hinge and keep an angel of 80degre the we have to place the strike in angular for and creat of mount in same proceess as the hinge mount is creted and then it is created
• now we have to create hemming for that we have to select outer pannel then then give an offset of 3mm downward direction and then we to take boundary offset of 8mm inwards direction
• and edges we to keep 3mm away as it is mention
• then trim it in inward direction now we he to then we have to thicken bothe outer pannel and inner pannel of 0.75 and outer pannel should be thicken in outward direction and inner pannel should be thicken in inward direction
• and last everthing should be assembel

AS THE HINGE IS IN SURFACE AND NOT IS SOLID FORM IN CATIA DUE TO WHICH I CANT ABLE TO ASSEMBLE IT PROPERLY