Fender Design - Wheel Arch Challenge
Fender wheel Arc
In this challenge we have to find wheel is inside the fender or out side the fender.
In automobile industry There are three regulations
Japan Regulation
European regulation
US regulation
European regulation
As per European regulation we have to find the at all the five section SA,SB,SC,SD and SE the clearance should be grater then 10mm
We have measure the value at wheal outer and fender inner
Step-1
We create the dataum plane on most outer surface of the tiyer and dot give any offset distend go with 0
After thet we have to sketch at the datam palne the we have to choose the center point then we crate tha line and project the curve and to mark the point the we project the point in feeder the we have to tack tha measure the value
Below value can be measured
|
location |
Required value |
Observed value |
Result |
|
S1 |
5 |
10 |
PASS |
|
S2 |
5 |
-9.94 |
FAIL |
|
S3 |
5 |
-0.15 |
FAIL |
|
S4 |
5 |
-2.8 |
FAIL |
|
S5 |
5 |
-5.9 |
FAIL |