Fender Design - Wheel Arch Challenge

Fender Design - Wheel Arch Challenge

EUROPOEAN REGULATIONS REQUIREMENT

Here i have use the european standard for the wheel arch at required cap measure CL L at sections SA-SA SB-SB SC-SC SD-SD SE-SE and produce CL check chart to validate.

At all five sections the CL L value should be greater than 10 mm to satisfy the European regulations.

Wheel guard reqmt: The value of 'a' shall be more than 5mm at a line 30* forward and 50* rearward from the central vertical axis of axis of wheel.

CLEARANCE CHECK TABLE

SECTION	REQUIRED VALUE	MEASURED VALUE	RESULTS
SA-SA	10MM	10 MM	OK
SB-SB	10MM	9.94 MM	OK
SC-SC	10MM	37.43 MM	NOT OK
SD-SD	10MM	30.35 MM	NOT OK
SE-SE	10MM	38.41 MM	NOT OK

Here i have Calculate the Wheel Arch gap at required points and check whether the car passes the European standard i found it is not passes the european standard we need to maintain distance between wheel arch and fender distance is 10mm