Design of backdoor

                                             BACK DOOR INNER PANNEL 

• extract the class A surface by using extracted geometory and offset the extracted surface to 2.65 mm.

• offset the edge (curve) of the offset surface by using offset curve in face of 7 mm.

• Extract the surfaces exept the which surface is not good .
• And create a bridge curve from the one end to another end of the surface where the surface is not extracted .
• two bridge curve at opposite sides,
• create a surface using throught curve mesh by using two bridge curve.

• trim the offset surface by curve which is created using offset curve in face.

• sew the extracted surface and the surface which as been ccreated by the through curve mesh.

• then create law extenction from the outer edge of the offset surface and the outer surface of class A surface.
• create a blend using three face blend from offset surface to class A surface.

•  extand the surface by using extend geometry and trim the surface  by using trim sheet.

• mirror the surface by using mirror geometry.

                                               BACK DOOR LOWER PANAL

• extract the class A surface by using extracted geometory and offset the extracted surface to 2.65 mm.

• offset the edge (curve) of the offset surface by using offset curve in face of 7 mm.

• trim the offset surface by curve which is created using offset curve in face.

• then create law extenction from the outer edge of the offset surface and the outer surface of class A surface.
• create a blend using three face blend from offset surface to class A surface.

• mirror the surface by using mirror geometry.

                                                               BACK DOOR UPPER PANAL

• extract the class A surface by using extracted geometory and offset the extracted surface to 2.65 mm.

• Extract the surfaces exept the which surface is not good .
• And create a bridge curve from the one end to another end of the surface where the surface is not extracted .
• two bridge curve at opposite sides,
• create a surface using throught curve mesh by using two bridge curve.

• trim the offset surface by curve which is created using offset curve in face.
• then create law extenction from the outer edge of the offset surface and the outer surface of class A surface.
• create a blend using three face blend from offset surface to class A surface.
• extand the surface by using extend geometry and trim the surface  by using trim sheet. 

• mirror the surface by using mirror geometry.